Installation; Preparation; Fitting The Legs - Dovre Houtkachel 40CB Instrucciones De Instalacion Y Uso

that can be ordered separately is not necessary for
connecting to the upper side via the attachment.
The appliance is supplied with a loose handle, the
so-called "cold hand".
In order to open the door, place the "cold hand" (A)
in the bolt (B) on the door; see the following figure.
After use, put the cold hand in the handle holder.

Installation

Preparation

Please check the appliance for damage caused
during transport or any damage or defects
immediately after delivery.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (the cast-iron inner
plates) from the appliance before you start
installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Subject to change because of technical improvements
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
1. Open the door.
2. Remove the cast-iron inner plates.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the
environment.

Fitting the legs

Fit the legs to the appliance; see the following figure.
1. Using the bolts supplied M6, fit the two parts of
the legs to the desired height.
2. Tilt the stove on its back.
3. Fit the four legs on the bottom plate using the
washers and the M8 nuts that are found on the
bottom plate.
7