Programming; Settings Table - BRÖTJE CIB C Montaje / Ajuste

Programming

GB
6. Programming
6.1

Settings table

Table 2: Setting the parameters
Function
LPB
Equipment address
Segment address
LPBConfig0.0
LPBConfig0.1
LPBConfig0.2
LPBConfig0.5
LPBConfig0.6
LPBConfig0.7
1) E = End user; I = Start-up; F = Specialist
LPBConfig0
(6606)
Time supplier
Feed function selection
Process water distribution
Priority LMU-requirement
24
• Only the most important parameters for the bus module CIB
C have been listed in the table!
• In order to get to the setting levels: End User (E), Start-up (l)
and Specialist (F), press button OK.; After this, press for appro-
ximately 3 s the Information button, select the reqired level
with the rotating knob and acknowledge with the button OK.
Detailed information for programming the integrated system con-
troller LMU 74 and setting tables with the programmable parame-
ters are contained in the installation manual of the boiler.
Configuration
Bit 0.0 = 0 and Bit 0.1 = 0: Autonomous
Bit 0.0 = 1 and Bit 0.1 = 0: Slave without remote setting
Bit 0.0 = 0 and Bit 0.1 = 1: System time master
Bit 0.2 = 0: Distributed bus feed OFF
Bit 0.2 = 1: Distributed bus feed AUTOMATIC
Bit 0.5 = 0 and Bit 0.6 = 0: own controller
Bit 0.5 = 1 and Bit 0.6 = 0: All controllers in the segment
Bit 0.5 = 0 and Bit 0.6 = 1: All controllers in combined operation
Bit 0.7 = 0: No priority
Bit 0.7 = 1: Priority before external capacity setting
Setting
Prog.-
Standard value
1)
No.
level
6600 I 1
6601 F 0
6606 F 0
F 0
F 0
F 0
F 0
F 0
AUGUST BRÖTJE GmbH
Modified
value