Electrical Connections - Stobag MOVENO DSRCE-V Instrucciones Y Advertencias Para La Instalación Y El Uso

2) Installation
Incorrect installation could cause serious injury.
Proceed as follows to prepare the motor:
1. Position the limit switch crown (E) on the motor (A) until it fits into the corresponding limit
switch ring (F); make sure that the two grooves match. Push it into position as shown
in Fig. 5.
2. Mount the drive wheel (D) on the motor shaft.
On MOVENO-U the drive wheel (D) snaps on automatically.
3. Fit the assembled motor into the winding roller until the crown (E) is fully inserted. Fasten the drive wheel (D) to the winding roller using the
M4x10 screw, so as to prevent the motor from slipping or sliding axially (fig. 6).
4. Finally, secure the motor head to the special support (C) with the spacer (if any), using the clips or split pin (B).

2.1) Electrical connections

For motor connections, an omnipolar disconnecting
device with a 3-mm minimum distance between contacts
must be provided for disconnection from the mains power
supply (disconnecting switch or plug and socket, etc.).
Carefully follow all the connection instructions, if you
have any doubts do not make experiments but consult the
relevant technical specifications sheets which are also
available on the web site www.stobag.com.
~
M1 M1
1 2 3 4 PE
1 2
1 2 3 4
1 2 3 4 PE
1 2
1 2 3
4
L
N
PE
2
3x1.5mm LNPE
(230VAC / 50Hz)
www.stobag.com
~ ~
M1
2
5x0.75mm
3 4 PE 1 2 3 4 PE
3 4 PE
1 2 3 4 PE
A: MOVENO DSRCE-V Tubular motor
B: Fastening clips or split pins
C: Support and spacer
D: Draw lock ring
E: Idle lock ring
F: Idle ring
An incorrect connection may be dangerous and cause
damage to the system.
The cable used for the electrical connections of the MOVENO
DSRCE-V motors has 5 wires; 3 of the wires (yellow tag) are for the
mains power supply and 2 wires (green tag) are for the command
signals.
For the electrical connections see the diagram below. The connec-
tion devices are not supplied with the product.
M1
L
N
PE
2
3x1.5mm LNPE
(230VAC / 50Hz)
~
2
5x0.75mm
GB
27