General Description; Preparation For Use; Automatic Ranges; Maximum Value (Max) - Chauvin Arnoux F 65 Manual De Instrucciones

3. GENERAL DESCRIPTION

3.1. PREPARATION FOR USE

3.1.1. POWER SUPPLY
Batteries:
Battery life:
3.1.2. INSTALLATION AND REPLACEMENT OF THE
BATTERIES
1.
is displayed when the voltage delivered by the
batteries is below the operating voltage.
2. Before replacing the batteries, set the switch to "OFF",
disconnect the measuring cords, and disconnect the clamp
from the circuit being measured.
3. Loosen the screw and open the cover of the battery
compartment with a screwdriver.
4. Replace the used batteries with two new 1.5 V LR03 batteries.
5. Put the cover back in place and tighten the attachment screw.

3.2. AUTOMATIC RANGES

Range selection is automatic for all functions. The AUTO symbol on
the display indicates this operating mode.

3.3. MAXIMUM VALUE (MAX)

In the Ac current and AC&DC voltage measurement modes, the
largest value can be measured simply by pressing the «MAX» button.
The MAX symbol then appears on the screen.
The acquisition time is 100 ms.
To deactivate this function, press the «MAX» button again.

3.4. HOLD MODE (HOLD)

The value displayed can be frozen simply by pressing the «HOLD»
button. The «HOLD» symbol is then displayed on the screen. To
deactivate this function, press the «HOLD» button again.
AAA or LR03 1.5 V (two)
45 hours (alkaline batteries)
25