Extremis Sticks Manual Del Usuario página 19

sticks enlightened
OUTDOOR RUBBER BASE
REPLACING A LED LIGHT BULB
The following operations may only be
carried out by a qualified electrician.
A. Make sure that all the bases are
disconnected from the electricity network!
B. Turn over the base and unscrew the
covering plate. Make sure that the earth
cable does not get detached from the earth
terminal. Remove the staples holding the
DETACHING WATERPROOF
CONNECTORS
Press down the locking tab with a flathead
screwdriver and turn the screwdriver 90
degrees to detach the two parts of the
connector.
cables in place. Disconnect the red and black
cable of the faulty LED light bulb by cutting
it off just after the heat shrink tube.
C. Remove the faulty light bulb from the
topside of the base, if necessary by pushing
from below. Insert a new EXTREMIS LED
light bulb and put the cables into the cable
channels. Keep them in place with a few
staples.
D. Connect the cables by means of the
supplied heat shrink tube.
E. Screw the covering plate onto the base
and turn over your Sticks.
english