Fan Assembly. Pgs - Craftmade Kodiak Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the 16in.
downrod provided to use with an extended downrod
(sold separately). [If you wish to use the 16in. downrod,
please proceed to instructions following the dotted line
below.]
To remove hanging ball, loosen set screw on hanging
ball and remove pin and clip from downrod. Lower
hanging ball and remove stop pin. Slide hanging ball
off the original downrod, A, and slide it down the
longer downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole when
setting the set screw). Insert stop pin into top of
extended downrod and raise hanging ball. Be sure
stop pin aligns with slots on the inside of the hanging
ball. Tighten set screw securely.
Tip: To prepare for threading electrical wires through
downrod, apply small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod.
Loosen yoke set screw and nut at top of motor
housing. Remove pin and clip from downrod (if you
have not already done so). Slide downrod through
canopy and then yoke cover.
NOTE: Be sure set screws on canopy and yoke cover
are loosened to prevent scratching of the downrod.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the downrod.
Place downrod into the motor housing yoke and
re-insert pin and clip that were previously removed.
Tighten yoke set screw and nut securely. Lower yoke
cover to motor housing. Tighten yoke cover set screw
at this time.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this
fan.
set screw
pin
A
downrod
set screws
clip
page 4
set screw hole
stop pin
hanging ball
clip
B
canopy
yoke cover
pin
motor housing