Blade Assembly; Wall Control Operation; Testing Your Fan - Craftmade Kodiak Guia De Instalacion

9. Blade Assembly.

Remove 6 blade screws/washers from
top of motor housing.
Attach one blade with 2 blade
screws/washers that were just removed,
as shown. [Note: Be sure to install blades
with ridged side facing up and flat side
facing the floor.] Tighten both blade
screws securely.
Repeat this procedure with remaining
blades.

10. Wall Control Operation.

0 - turns fan OFF
1 - turns fan to LOW speed
2 - turns fan to MEDIUM-LOW speed
3 - turns fan to MEDIUM speed
4 - turns fan to MEDIUM-HI speed
5 - turns fan to HI speed

11. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from
circuit box. Test fan speeds with wall
control. Start at the OFF ("0") position (no
blade movement) and try each of the 5
different fan speeds.
If fan does not function, please refer to
"Troubleshooting" section to solve any
issues before contacting Customer Service.
motor housing
page 7
blade screws/washers
blade