Wiring - Wall Control; Canopy Assembly - Craftmade Kodiak Guia De Instalacion

7. Wiring - Wall Control

Remove existing wall switch. Remove
screw at the bottom of the wall control.
Then, remove back plate from wall
control by pulling out gently from the
bottom.
Connect BLACK (TO MOTOR L) wire from
wall control to BLACK (AC TO FAN) wire
from wall.
Connect BLACK (AC IN L) wire from wall
control to BLACK (AC IN) wire from wall.
Use wire connectors provided when
making connections.
* Wrap each wire connector separately
with electrical tape as an extra safety
measure. Gently push spliced/taped wires
and wire connectors into outlet box.
Align slots at top of wall control with tabs
on backplate. Push bottom of wall control
until flush against the wall. Re-insert
screw that was previously removed to
secure wall control.

8. Canopy Assembly.

Lift canopy until it covers hanging bracket and
touches ceiling. Tighten canopy set screw to
secure canopy.
black black
(AC TO FAN)
outlet
box
back
plate
black black
AC IN
set screw
page 6
tab
black black
black black
TO
AC TO
MOTOR L
FAN
black black
black black
AC IN
AC IN L
wall
control
*
back plate
screw
canopy
slot