Troubleshooting - Campingaz RBS 3 Series Utilización Y Mantenimiento

Hand them in to the waste collection service in your
municipality and sort the packing materials.
t) BATTERy RECOMMENDATIONS
This symbol found on the batteries means that at
the end of their lives, the batteries must be
removed from the unit, and then recycled or
properly disposed of. The batteries should not be thrown
into the trash, but should be brought to a collection point
(dump...). Check with your local authorities. Never dispose
of in nature, do not incinerate: the presence of certain
substances (Hg, Pb, Cd, Zn, Ni) in used batteries may be
hazardous to the environment and human health.
w) Troubleshooting
Problems
Burner won't light
Burner "pops" or blows
itself out
Excessive flare-up
Burner lights with a match,
but not with the electronic
igniter
Probable causes /
remedies
- Lack of gas supply
- Regulator does not work
- Hose, valve, jet, venturi
tube or burner openings are
blocked.
- Venturi tube not seated over
jet
- Check gas supply
- Check hose connections
- Contact the After Sales
Service
- Clean the protective plate
above the burner.
- Clean the grease drip tray
- Grill temperature too high:
lower flame
- Faulty igniter, wire
electrode
- Check igniter cable
connections
- Check condition of electrode
and connection wire
- Contact the After Sales
Service
u) ELECTRICAL AND ELECTRONIC WASTE
This symbol means that the appliance's electrical
system must be disposed of selectively. At the end
of its life, the appliance's electrical system must be
scrapped correctly. The electrical system must not be
disposed of with unsorted municipal waste. Selective
collection of waste promotes reuse, recycling or other
forms of recovery of recyclable materials contained in this
waste. Take the appliance's electrical system to a waste
recovery centre designed for the purpose (waste collection
point). Check with your local authorities. Never dispose
of in nature, do not incinerate: the presence of certain
hazardous substances in electrical and electronic
equipment can be harmful to the environment, and have
a potential effect on human health.
Problems
Fire at any connection
Incomplete flame around
burner
Lack of Heat
Fire behind control knob
or
Fire under control panel
13
Probable causes /
remedies
- Leaking connection
- Turn off gas supply at
cylinder immediately
- Tighten connections and
check for leaks
- Contact After Sales Service
- Defective or clogged
burner: relocate the Venturi.
- Clogged jets: clean the
Venturi
- Contact After Sales Service
- Clogged jet or venturi tube
- Contact After Sales
Service
- Defective tap unit
- Turn off gas supply at
cylinder immediately
- Contact After Sales Service
- Turn off gas supply at
cylinder immediately
- Contact After Sales Service
GB