Safety Information - Hydor Slimskim 250.65 Manual Del Usuario

Slimskim 250.65
Dear Customer,
Thank you for choosing this quality product. Please read the following instructions very carefully
for the best understanding of the characteristics of this new, innovative product.
Hydor' s new Slimskim skimmer is equipped with a special adjustable collection cup, and one
pump for both foaming and water supply. It is designed to be easily taken apart for quick and
simple maintenance.
The height regulation of the collection cup can be adjusted by the positioning of the o-ring. This
allows for precise foaming regulation.
Attention: Slimskim skimmer is speci cally designed for use in aquariums. Please refer to your dealer for any
other application.

Safety information

Attention: please verify that all components of the skimmer are undamaged before putting it into function.
Before placing hands in the aquarium, always disconnect from mains all electrical devices immersed in water.
Verify that the voltage of the mains supply corresponds to the voltage shown on the unit' s label.
The pump is intended for indoor use only in uid with a temperature of max. 35° C (95° F)
DO NOT RUN DRY - Do not connect to electrical supply if pump is not completely immersed in water.
Do not connect to electrical supply if pump is missing parts.
The cord of this pump cannot be replaced or repaired; in case of damage the entire unit must be substituted.
Do not cut or pull on the electrical cord.
Always disconnect from mains gently.
Make sure hands are dry before touching and disconnecting any electrical supply.
To avoid any danger of shock remember to keep always keep all connections dry.
Verify that the mains are clean and are not humid or encrusted with salty deposits..
Please keep these instruction in a safe and dry place.
Description
Skimmer body/column
A.
Separation for water intake chamber
B.
Back panel
C.
Collection cup lid
D.
Collection cup
E.
Pump chamber
F.
Impeller cover
G.
Air intake chamber
H.
Impeller
I.
Shaft
L.
Assembly
Slimskim is rst supplied with the pump already assembled and in the correct position. The following instructions
(from g. 1 to 14) should be followed closely when carrying out maintenance and/or replacing parts.
Click the air intake chamber (H) on the motor (N) – g.1
Motor dupport
M.
Motor
N.
O-ring
O.
Black air tube
P.
Connector
Q.
Magnet + suction cup
R.
Clips
S.
Air ow control
T.
Grid
U.
English 9