Bang & Olufsen BeoSound 1 2581 Guia De Reparación Para El Usuario página 38

TM 27: Get errors
TM 31: Set default settings
TM 32: Get product ID
Get and delete error info. The last 16 errors are stored.
N n
Press / or press
After 1.5 sec the error-code is displayed.
0150 -> 0753 : Internal SW-errors. These error-codes are used only for debugging
during SW-development.
0A00 -> 0A80 : Error on IIC-bus 0 (the fault is on PCB1).
0B00 -> 0B80 : Error on IIC-bus 1(the fault is on PCB1 or PCB3).
0C01 -> 0C20 : EEPROM error
0D00 -> 0D02 : Error in Theft Protection HW
0D03 : Theft Protection functionality not initialized
0D80 : The product has been in the Theft Protection Locked state (PIN-code
requested). This is not an error, only an information.
0E01 : Primary speaker setup data missing.
0E02 : Primary amplifi er setup data missing.
0E71 : Power supply error
0E72 : Amplifi er error
0F01 -> 0F12 : CD-module errors
O
Press or STORE to display how many errors in all.
O
Press or STORE to reset errors and end TM, or press
to store errors and end TM.
Sets default values in NVRAM. Sound values is set to neutral and radio programs
are cleared. The test mode ensure that the product is ready for sale.
The test mode will not be executed if:
The error queue is not cleared/empty. It is possible to clear all errors by TM 27.
The product missing product ID. By TM 32 it is possible to verify product ID.
The theft protection is uninitialized, enabled or active (locked). By executing TM 92
it is possible to verify the state of the theft protection.
The display will show "run" during the TM and if an error occurs the display will
show " Err". Otherwise the display will show "NoEr" and the TM is ended.
Gets the identifi cation data on the product.
N n
Press / or press
A fl ashing digit indicates that there is one or more digits hidden outside the display.
I no = (item number) 7 digits
O
Press or STORE to continue.
Yno = (Type number) 4 digits
O
Press or STORE to continue.
Sno = (Serial number) 8 digits
O
Press or STORE to continue.
Pno = (Theft protection data)
O
Press or STORE to continue.
If the theft protection data is OK the display shows "NoEr".
Otherwise the display will show "Err"
O
Press or STORE to end TM.
Adjustments, English
L l
/ to toggle between errors.
L l
/ to scroll for viewing hidden digits.
5.5
T
or STOP