KLeefer GLOBBER ONE K E-MOTION Manual Del Propietário página 4

Keep the instructions for future.
NF-EN-14619
READ THE INSTRUCTIONS PROVIDED BY THE MANUFACTURER BEFORE USING. MAXIMUM WEIGHT: 100 KG
Warnings
- The scooter is reserved for adolescents and adults. It is not a toy, but sports equipment for physical training, it is not intended for use in extreme
sports such as jumping, ollie ramps, etc. This product should never be used at a skate park for an "aggressive" use (challenging skateboarding
moves, etc.).
- Use with caution on a flat, clean, dry surface and, if possible, away from other users, and obey the road safety rules.
- Check local laws regarding scooter use, respect all the traffic rules and signs. Stay away from other pedestrians or users on public roads.
- Best when used on a flat, dry surface free of gravel and grease. Avoid bumps and drainage grates that might cause an accident.
- Warning! Protective equipment consisting of wrist protectors, gloves, knee pads, helmets and elbow pads should be worn.
- Do not touch the hub motor located in the front wheel when in use or immediately after riding.
Using the scooter
• Before and after each use: To prevent pinched fingers, carefully follow the instructions of unfolding and folding. Make sure that the locking
mechanisms are securely locked:
- Check the height of the steering system and make sure that the nuts are tightened and the handlebars and front wheel are perpendicular.
- Check all connected elements; the brake and the wheel axles must be correctely adjusted, and must not be damaged.
- Also check the tire wear.
• Braking:
- Handlebar brake: left brake handle slows the back wheel. When using, keep riding the scooter with both hands.
- The drum brake located on the rear wheel may heat up after multiple uses. Avoid touching it and the rear wheel.
Assembling the product
- The folding and unfolding operations of the scooter are to be done by a single person.
- During these operations, be careful you do not get your fingers stuck in the hinge and locking system.
- Make sure that the locking devices are properly engaged.
1. Display
4
2. Left handside handlebar
1
3. Rear brake lever
4. Right handside handlebar
5. Lower cover
6. Front wheel drive
7. Folding foot pedal
8. Rear mudguard
9. Rear drum brake
10. Deck
11. Removable battery
12. Side stand
13. Rear wheel
14. LED light
15. On/Off switch
16. Charger port
17. Throttle
Display details
5
The screen gives you 5 pieces of information:
A. Battery indicator
B. Speed
C. Driving mode selected
D. Overall distance covered
6
E. LED light (ON/OFF)
B. SPECIFICATIONS REGARDING THE USE OF THE ONE-K E-MOTION
a. Before riding your scooter
i. Brake adjustments
- Ensure that cables are not frayed or bent. Otherwise you will have to change the rear brake cable by contacting the supplier.
- Pulling the lever should stop the rear wheel without having to pull it all the way to the handlebar. Otherwise, decrease the responsiveness of the
brake by using the cylinder button on the handle bar. The optimal responsiveness is 1 to 3 mm.
ii. Lubrication
- Globber ONE K E-MOTION bearings may require the use of lubricant. In this case, always use grease or oil made specifically for bearings.
Scooter-bearing oils need to be thin enough to penetrate small gaps, they should be durable so they can withstand exposure to the elements,
and they must resist the accumulation of dirt.
4
2
3
14
11
C
8
7
A
9
13
10
12
b. Riding your scooter
i. Description of the Electric assistance
- The scooter can be operated in two modes : slow mode limits the speed to 6km/h. Fast mode limits the speed to 25km/h
- Electric assistance: the unit must be traveling at least 3MPH (5km/h) before the motor will engage. Kick start at least 3MPH (5km/h) by applying
the throttle to engage the motor.
Hints and tips for controlling the scooter
- Make sure your environment is suitable for using the scooter.
- Do not use on wet days, or on wet ground.
- Do not ride at night or when visibility is limited without turning on the LED light.
- Always wear shoes.
- Use on a clean, flat, dry surface, far from the other road users. Avoid steep slopes.
- Ensure that you hear a "click" sound to ensure that the system is locked. Check it by pulling back before you start to ride.
ii. Riding position
iii. Turning the scooter on/off
- After turning on the battery, press the "
This turns on the display.
- When you press "
- The E-MOTION has 2 speed modes: Slow mode (mandatory in pedestrian areas)
limited to 6km/h.
When turned on, "SLOW" appears on the screen. And a fast mode with a 25km/h max speed.
When turned on, "FAST" appears on the screen. Switch from one mode to the other without releasing
the handlebar by pressing "
- Press the "
- The scooter will switch off automatically after 3 minutes if there is no activity.
c. After riding your scooter
i. How to charge your scooter
16
15
C. BATTERY SPECIFICATIONS
E
a. Information (technical information)
- The battery will work from -15°c to 50°c
B - We recommend that the product be used at temperatures between -5°c to 30°c
D
ITEM
Battery type
17 Charging time
Voltage
Initial capacity
Working temperature
Charging temperature
Storage time(~20°c and 25°c)
Stored relative humidity
b. Recommendations for charging the battery and charger use
- Charger spec INPUT: 100-240V AC OUTPUT: DC 42V / 1.5A
- First, check to make sure that you have the correct charger. Make sure that the voltage is accurate for your scooter.
- Plug the charger into your electrical power outlet. The light should turn green.
- Next, plug the charger into the charging port on your Globber ONE K E-MOTION scooter. Make sure that it is correctly inserted into the charger
port. The light should now be solid red.
- When charging is complete (4 hours) and the charger has turned green again, unplug the charger from the wall socket and then the
charger port.
- You should now be ready to go.
/ " button down for a few seconds.
/ " briefly, it will activate/deactivate the LED light
".
/ " button again for a few seconds. This turns off the display.
DESCRIPTION
Lithium-ion battery
4 hours
36v
5.8AH
-15°c - 50°c
0-40°c
12 months
5%-95%