To Adjust Temperature; To Activate Smart Fan; Automatic Component Protection - Friedrich WallMaster WS Instrucciones De Instalación Y Funcionamiento

also run to test the temperature if the off cycle is too long. Or
you may prefer con stant fan for more air move ment. (To return
to constant fan, touch the MODE button two more times).
In order to run the fan by itself, do the following:
3 Continuing from MoneySaver
MODE button once to activate the FAN ONLY feature
(light on).
The FAN ONLY setting will circulate air in the room without
the compressor coming on.

To adjust temperature

4 Use the MODE button to select either the COOL or
®
MoneySaver function
5 COOLER – Touch the downward-pointing triangle
with the minus symbol, (
temperature.
6 WARMER – Touch the upward-pointing triangle with the
plus symbol ( ) to raise the room air temperature.
7 Press both the and
the temperature from Fahrenheit (°F) to Celsius (°C).
Repeat step 7 to switch from °C back to °F.
To adjust fan speed
8 Touch the FAN SPEED button to see the current setting.
Touch it again to change speed. F1 is the lowest setting
(SLEEP SETTING / LOW), F2 is MEDIUM, and F3
is HIGH.

To activate Smart Fan

9 There is a fourth option, SF, when selecting the fan speed.
This is the SMART FAN function. SMART FAN DOES
NOT OPERATE IN CONJUCTION WITH THE FAN
ONLY MODE.
Smart Fan will adjust the fan speed automatically to maintain
the desired comfort level. For example, if the outside doors in
your home are opened for an extended period of time, or more
people enter a room, Smart Fan may adjust to a higher fan
speed to compensate for the increased heat load. This keeps
you from having to adjust the fan speed on your own.
920-007-11 (8-05)
®
mode (light on), touch the
) to lower the room air
at the same time to switch
To set the hour clock
10 Touch the SET HOUR button to see the current setting.
The number that is displayed is the approximate time
(hour only). Use the two triangle-shaped buttons (
and ) to change the settings. BE SURE TO SET
A.M. AND P.M. ACCORDINGLY. (P.M. is indicated
by a red light in the upper left corner of the display).
To set the timer
NOTE: Set the HOUR CLOCK before attempting to set
timer functions.
You can set the START and STOP times a minimum of one
hour apart, and a maximum of twenty-three hours apart.
11 After setting the time, press the SET HOUR button once
(Start light on). Use the two triangle-shaped buttons
( and ) to select the time that the unit will
START.
12 After selecting the START time, press the SET HOUR
button once. (Stop Light on). Use the two triangle-shaped
buttons ( and
will STOP. After selecting the stopping time, press the
SET HOUR button once.
13 Press the TIMER ON / OFF button (light turns on) to
activate the timer function. To deactivate this function,
press the TIMER ON / OFF button once again (light turns
off). Once the on and off times have been selected, they
will remain in memory and cycle daily until changed.
NOTE: If the unit is unplugged or the power is interrupted,
the HOUR must be reset or the TIMER ON / OFF will not
function when desired.

Automatic component protection

Your unit is equipped with Automatic Component
Protection.
To protect the compressor of the unit, there is a three minute
delay if you turn the unit off or if power is interrupted. The fan
will not be affected. Also, if you switch from COOL mode to
FAN ONLY mode, and switch back to COOL mode, there is a
three-minute delay before the compressor comes back on.
) to select the time that the unit
3