Fan Assembly. Pgs - Ellington Craftmade MR56ESP4C1 Guia De Instalacion

5. Fan Assembly.
Remove hanging ball from downrod provided by loosening
set screw on hanging ball. Lower hanging ball and remove
stop pin and then slide hanging ball off of the downrod.
[Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor housing.
Remove pin and clip from motor housing yoke. [Refer to
diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the ends
of the electrical wires--this will keep the wires together
when threading them through the downrod. [Refer to
diagram 2.]
Determine the length of downrod you wish to use. Thread
safety cable and electrical wires through threaded end of
downrod and pull extra wire slack from the upper end of the
downrod. [Refer to diagram 2.]
Thread downrod into the motor housing yoke until holes for
pin and clip in downrod align with holes in yoke--make sure
wires do not get twisted. Re-insert pin and clip that were
previously removed. Tighten yoke set screws and nuts
securely. [Refer to diagram 2.]
Slide yoke cover and canopy over downrod. [Refer to
diagram 3.]
Thread wires through hanging ball; then slide hanging ball
over downrod--the top of the downrod should be noted as
having a set screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and raise hanging
ball. Be sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely. [Refer to diagram 4.]
Remove electrical tape from electrical wiring and thread
each of the wires through a different hole in the
weatherproof hanging ball cover. Pull weatherproof
hanging ball cover down securely over hanging ball (on
downrod). [Refer to diagram 4.]
WARNING: Failure to tighten set screw on hanging ball
completely could result in the fan becoming loose and
possibly falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
diagram 1
electrical wiring
motor
housing
diagram 2
canopy
diagram 3
electrical wiring
stop pin
canopy
diagram 4
page 4
stop pin
hanging ball
yoke set
screw
downrod
and nut
clip
downrod
yoke cover
motor
housing
weatherproof
hanging
ball cover
set screw hole
set screw
hanging ball
pin