Ellington Craftmade MR56ESP4C1 Guia De Instalacion página 9

9. Light Kit Assembly. (cont.)
Raise glass shade in order to guide pull chains
through holes at the bottom of the glass shade. Align
threaded rod on light kit fitter with hole in middle of
glass shade and push up gently allowing threaded
rod to come through hole. (Be sure pull chain for fan
operation does not rub against bulb during
operation.) Secure glass shade to light kit fitter with
threaded washer.
pull chains
Note: Do not overtighten threaded washer as glass may
threaded washer
crack or break.
finial plate
Thread pull chains through corresponding holes in
finial
finial plate and center pull chain through hole in
finial. Tighten finial.
Note: Do not overtighten finial as glass may crack or
switch housing plate
break.
Very gently raise wire housing to switch housing
plate, aligning holes in the wire housing with the
wire
housing
holes in the 4 posts on the switch housing plate. [Be
sure to avoid bumping the glass shade while raising it
as this may cause chipping or scratching of the glass.]
Secure wire housing with 4 decorative nuts that were
previously removed. Tighten all 4 decorative nuts
securely.
decorative nuts
page 8