Wiring - Ellington Craftmade MR56ESP4C1 Guia De Instalacion

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with the
hanging bracket tab.
WARNING: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury
or death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.

6. Wiring.

WARNING: Turn off circuit breakers to current fixture from
breaker panel and be sure switch is turned to the OFF
position.
CAUTION: Be sure outlet box is properly grounded and that a
ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes
or Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building wires
are different colors than those referred to in the instructions
below, please use a qualified electrician.
Note: Excess lead wire length from the fan can be cut to the
desired length and then stripped.
DANGER: If using this fan in a WET or DAMP location, this
fan must be connected to a supply circuit that is protected
by a Ground Fault Circuit Interrupter (GFCI) to reduce the
risk of personal injury, electrical shock or death.
When fan is secured in place on the hanging bracket,
electrical wiring can be made as follows:
Connect BLACK and BLUE wires from fan to BLACK wire
from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from ceiling
with wire connector provided.
Connect all GROUND (GREEN) wires together from fan to
BARE/GREEN wire from ceiling with wire connector
provided.
If you intend to control the fan light with a separate light
switch connect BLUE wire from fan to the BLACK (or RED)
supply from the independent switch.
* Wrap each wire connector separately with electrical tape
as an extra safety measure.
white supply wire
black supply wire
from ceiling
black
white
white
black
blue
from fan
(wiring for fan)
This fan is remote control adaptable (remote
control sold separately). Note: Only remote
controls approved for WET locations can be
used with this fan.
page 5
hanging bracket tab
hanging ball slot
motor housing
ground
(green or bare)
ground
(green
or bare)
*