Canopy Assembly; Blade Assembly - Ellington Craftmade MR56ESP4C1 Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of of
the hanging bracket. Partially loosen the other
screw. Lift canopy to hanging bracket. Place
rounded part of slotted hole in canopy over
loosened screw in hanging bracket and push up.
Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely.

8. Blade Assembly.

Time Saver: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 12 blade attachment screws and
washers in hardware pack. Hold blade arm
up to blade and align holes. Insert 3 blade
attachment screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat
for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade arm
screws and lock washers to secure blade
arms). Align blade arm holes with motor
screw holes and attach blade arm with lock
washers and blade arm screws. Before
securing screws permanently, repeat with
remaining blade arms. Securely tighten all
screws.
Note: Tighten blade arm screws twice a year.
screw
canopy
lock washers
page 6
hanging bracket
screw
motor housing
blade attachment
screws and washers
blade
blade arm
blade arm screws