Troubleshooting - Harman Kardon SoundSticks II Manual De Instalación Rápida

SoundSticks
Specifications*
System
Frequency range: 44Hz – 20kHz
Power consumption: 4W idle, 65W maximum
Subwoofer
Transducer (1): 6" woofer
Amplifier output power: 20W RMS
Dimensions (W x H): 9-3/16" x 10-3/16"
(232mm x 258mm)
Weight: 4 lb (2.2kg)
Satellite
Transducers (4): 1" full-range per channel
Amplifier output power: 10W RMS per channel
Dimensions (W x H): 2" x 10" (51mm x 254mm)
Weight: 1.5 lb (0.7kg)

Troubleshooting

Symptom
No sound from SoundSticks II
speaker system.
*These specifications are subject to change without notice.
12
II easy setup guide
®
Step 1. Place indi-
vidual SoundSticks
II (satellites) beside
monitor/computer.
Possible problem
No power to subwoofer.
Power adapter plug not in-
serted correctly.
No volume or low volume.
Step 2. Place sub-
woofer as desired,
®
but placement under
your desk will provide
optimal performance.
Solution
Ensure power supply is connected to live power source and is
properly connected to subwoofer.
Please note: When subwoofer is powered, a power LED should light.
Place plug with arrow symbol facing UP into the subwoofer.
Touch the volume "Up" ( + ) pad on the volume control satellite to
unmute and/or increase the system volume level.
Note: Touching the volume "Down" ( – ) pad lowers the system vol-
ume. Touching both ( + ) and ( – ) volume control pads at the same time
will mute the system.
Step 3. Connect sat- Step 4. Insert Sound-
ellites to subwoofer. Sticks II input cable
into the computer or
other audio device.