Programming 1 Button Remote - Craftsman 200.57933 Manual Del Propietário

Programming 1– Button Remote
To prevent SERIOUS INJURY or DEATH:
- Keep remote and battery out of reach of children.
- NEVER permit children to access the wall panel nor remotes.
- Operate the door ONLY when it is properly adjusted, and there are no obstructions present.
- ALWAYS keep a moving door in sight until completely closed. NEVER cross the path of a moving door.
To reduce risk of fire, explosion or electric shock:
- DO NOT short circuit, recharge, dissemble or heat the battery, batteries may explode or leak.
- NEVER allow small children near batteries.
- Replace with 23AE 12 volt batteries ONLY. Dispose of batteries properly.
Signal and
Battery Indicator
LEARN
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
20
WARNING
!
To Program Remote(s):
1.
Visor Clip
2.
Holster
3.
Fig.1
Up to 20 remotes (including keyless entry pad codes) can be
added to the unit by repeating the above procedures.
If more than 20 remotes are stored, the first stored remote will
be replaced. (i.e. the 21st remote replaces the 1st stored
remote.)
* If the courtesy light is already on, it will flash once and stay
30
illuminated for 30 seconds.
seconds
Fig.2
** If a remote is not accepted, the courtesy light will stay on for
30 seconds, flash 4 times and then stay on for 2-1/2
minutes. Retry programming the remote by repeating the steps
above.
x2
Removing all Remotes:
To remove all remotes from memory, press and hold the
"LEARN" button for 5 seconds. The courtesy light will flash 7
Fig.3
times indicating all remotes have been removed from memory.
Replacing Remote Battery:
When the battery of the hand held remote is low, the indicator
light will become dim and/or the range of the remote will
23AE 12 Volt
diminish. To replace the battery, remove the battery cover from
Alkaline Battery
the remote as shown in Fig 4. Replace with a 23AE 12 volt
alkaline battery with polarity shown in Fig.4.
Fig.4
See Fig.2 to add a remote. Press the "LEARN" button on
the rear control panel of the opener. The courtesy light will
illuminate with an audible click*. The unit is now ready to
learn a remote.
Within 30 seconds, press the button on the remote.
The courtesy light will flash twice indicating remote has
been stored successfully**.