Product Maintenance - Fellowes Powershred 46Ms Manual De Instrucciones

BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after each pass
to clear entry. Continuous operation beyond
15-minutes will trigger 25-minute cool down period.
ADVANCED PRODUCT FEATURES
SafeSense ® Technology
Stops shredding immediately when
hands touch the paper entry.
SAFESENSE ® TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
(–) to activate SafeSense look for the SafeSense
®
indicator to illuminate
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
indicator will remain illuminated and the shredder will
the continuous operation and recovery time for this shredder.
SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
PAPER OR CD/CARD
1 2
Plug in and put Feed paper/card
disconnect power straight into paper
entry and release
SilentShred™ Technology
shreds without noisy disruptions.
3
SafeSense is active and
®
working properly
®
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
TO CLEAN THE SENSORS
1
unplug shredder
or
Hold CD at edge, feed
into center of CD entry
and release
Sleep Mode
the shredder after 2 minutes
of inactivity.
SLEEP MODE OPERATION
2 minutes of inactivity.
WHEN IN SLEEP MODE
1
In sleep mode
2
Locate Auto-start
( ) and
infrared sensor
indicator will illuminate and the shredder will stop shredding.
®
3
)
Auto Reverse
Stops and reverses paper
if a jam occurs.
2
insert paper
.
4
3
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
3