Front Panel Explanations - Atlantis A03-S1000LE Manual De Instrucciones

1.8 Front Panel Explanations

A03-S1200
On the front panel You can found LCD panel for an easy end complete diagnostic.
LCD/Button
Main Switch
[ ]
Information
Press the UPS On/OFF [
seconds, then the Buzzer sounds twice/3 times, the UPS will
be start-up/Switch OFF.
To enable "DC-Start" Function when Utility fails. (To enable
DC Start properly, you are recommended to connect <80%
output load with the UPS only). P.S. Make sure the
computer connected to the UPS is switched on before
enable the "DC-Start" function. You are not recommended
to add some other computer or peripherals after DC-Start
function is activated.
Line mode. Measurement Target & Value (Input AC, Output
AC).
Battery mode. Buzzer alarms (every 30 seconds), every
seconds when UPS is in battery low condition.
Bat mode: battery capacity
Line mode: [1. Battery charging: cycle lighting, 2. Battery
full charged: lighting, 3. Line mode without charger: battery
capacity]
Load capacity.
Fault.
25
] Switch for approx. 2/3
ENG