IFU 4010020738 - Adelaide Plancha - pages 12 to end.qxp
- Clean the top of the burner, as well as the sides and
base, using a moist sponge (water with washing up
liquid). If necessary, use a damp steel brush.
- Check that all burner outlets are clear and let dry before
using again. If necessary, use a wire brush to unclog the
burner outlets.
- Refit the grill burner correctly.
- Clean the orifices on the Venturi jet (see diagram below)
or the burner if necessary.
N.B.: Frequent cleaning of the burner maintains it in good
condition for many uses and prevents premature oxidation,
notably due to acid residue from cooking. Oxidation of the
grill burner is, however, normal.
Base walls, control panel, grease recipient
Clean these elements from time to time using a sponge
with washing up liquid. Do not use abrasive products.
Cooking surface
The cooking surface is covered with enamel. To clean it,
we recommend first removing all cooking residues with a
sponge. Next, remove grease with a dishwashing
detergent.
Be careful to avoid hitting the cooking surface against a
hard surface since this could chip the enamel.
Enamelled steel cooking surface (depending on the
model):
Do not use cold water or ice on the cooking surface when
still hot, as this could lead to damage (deformation).
n) STORAGE
- Close the gas cylinder valve after use.
- If you store your barbecue indoors, disconnect the gas
cylinder and store the cylinder outdoors.
- If you store your barbecue outdoors, it is recommended
that a protective cover be used.
10/10/2013
- When not used for a long period of time, it is
recommended that the barbecue be stored in a dry,
sheltered place (eg: garage).
Transport (models L and LX)
To transport the appliance, always carry it in a horizontal
position using the two side handles; never carry it
vertically.
o) ACCESSORIES
ADG ('Application Des gaz') advises that its gas
barbecues should systematically be used with
accessories
and
replacement
Campingaz®. ADG accepts no responsibility for any
damage or malfunction due to the use of accessories
and/or replacement parts from other brands.
p) PROTECTING THE ENVIRONMENT
Think about protecting the environment! Your equipment
contains materials which can be recovered or recycled.
Hand them in to the waste collection service in your
municipality and sort the packing materials.
13
11:40
Page 4
GB
parts
from