Protecting The Environment - Campingaz Woody L Utilización Y Mantenimiento

completely before putting on its protective cover.
at the beginning of the season, apply a coat of lazure for
exterior wood on the wooden parts with a rag or brush to
give it a shinier appearance and keep it protected.
p) STORAGE
- close the gas cylinder valve after use.
- if you store your barbecue indoors, disconnect the gas
cylinder and store the cylinder outdoors.
- if you store your barbecue outdoors, it is recommended
that a protective cover be used.
- When not used for a long period of time, it is recommended
that the barbecue be stored in a dry, sheltered place (eg:
garage).
- environment conducive to corrosion: particular care must
be taken with the product if used by the sea; it must not
be stored outside without protection, and must be kept
sheltered in a dry environment.
Problems
Burner won't light
Burner "pops" or blows
itself out
excessive flare-up
Burner lights with a match,
but not with the "PieZo"
igniter
Probable causes /
remedies
- Lack of gas supply
- Regulator does not work
- Hose, valve, jet, venturi
tube or burner openings are
blocked.
- venturi tube not seated over
jet
- check gas supply
- check hose connections
- contact the after sales
service
- clean the protective plate
above the burner.
- clean the grease drip tray
- grill temperature too high:
lower flame
- Faulty igniter, wire or
electrode
- check igniter cable
connections
- check condition of electrode
and connection wire
- contact the after sales
service
9
q) ACCESSORIES
ADG advises that its gas barbecues should systematically
be used with accessories and replacement parts from
Campingaz . ADG accepts no responsibility for any
®
damage or malfunction due to the use of accessories and/
or replacement parts from other brands.
r) PROTECTING THE ENVIRONMENT
think about protecting the environment! Your equipment
contains materials which can be recovered or recycled.
Hand them in to the waste collection service in your
municipality and sort the packing materials.
Problems
Fire at any connection
incomplete flame around
burner
Lack of Heat
Fire behind control knob
Fire under control panel
GB
Probable causes /
remedies
- Leaking connection
- turn off gas supply at
cylinder immediately
- tighten connections and
check for leaks
- contact after sales service
- defective or clogged
burner: relocate the venturi.
- clogged jets: clean the
venturi
- contact after sales service
- clogged jet or venturi tube
- contact after sales service
- defective tap unit
- turn off gas supply at
cylinder immediately
- contact after sales service
- turn off gas supply at
cylinder immediately
- contact after sales service