Connections - Axxess AXDIS-CH5 Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an AX-LCD (sold separately), there will be an accessory wire from the
AXDIS-CH5 harness to connect as well.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Tape off and disregard the following (10) wires, they will not be used in this application:
Blue/White, Brown, Gray, Gray/Black, Green, Green/Black, Purple, Purple/Black, White and
White/Black.
2

CONNECTIONS

From the AXDIS-CH5 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Disconnect the (2) 4-pin connectors that have Green, Green/Black, Purple, and Purple/Black wires.
• Connect the 4-pin harness with stripped leads to the 4-pin connector from the gray 22-pin
connector.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• If retaining the factory backup camera, connect the Yellow RCA jack to the reverse camera input.
• If the AUX-IN jack in the dash is desired to be used, connect the Red and White RCA jacks to
the audio AUX-IN jacks of the aftermarket radio.
• The DIN jack is to be used with the optional AX-LCD (sold separately) to retain the
personalization features of the vehicle.
• Connect the Red wire to the accessory wire.
Continue to 3.5mm jack steering wheel control retention