Skil PWRCORE 12 Manual Del Propietário página 13

Install and Remove the Socket
3/8 inch Socket
a. Remove the battery pack.
b. Simply push the 3/8 inch socket (not
included) completely onto the square drive
anvil (Fig.6).
c. To remove the socket, just pull it off.
1/4 inch Socket
a. Remove the battery pack.
b. Push down the 3/8" to 1/4" adapter (included)
onto the square drive anvil, then push the
1/4 inch socket completely onto the adapter
until it locks into place (Fig.7).
c. To remove the socket, simply pull it off.
WARNING
Sockets not designed for wrenches could
break and result in user injury. Inspect sockets
prior to use to ensure that they have no cracks
or other visible damage.
WARNING
the tool, or first allow it to cool down. The
socket may be hot after prolonged use.
Operating with the Ratchet
Wrench
WARNING
Therefore, always remove the battery pack
when the tool is not in use or when carrying it at your side.
The proper fastening torque may differ, depending on the type or size of the bolt, the material
of the workpiece to be fastened, etc. Before starting your job, always perform a test operation
to determine the proper fastening time for your bolt or nut.
a. Check the direction-of-rotation selector for the correct directional setting (forward or
reverse).
b. Hold the tool firmly and place the socket over the bolt or nut.
c. Slide the lock-off switch to the unlocked position and then depress the paddle switch to
turn the ratchet wrench on. The paddle switch delivers higher speed with increased trigger
pressure and lower speed with decreased trigger pressure.
d. Fasten the bolt or nut to the proper torque.
e. To turn the wrench OFF, release the trigger switch.
f. After fastening, always check the torque with a torque wrench.
NOTICE: Hold the tool straight along the axis of the bolt or nut.
Only use sockets designed
for ratchet wrenches.
Use protective gloves when
removing the socket from
Battery tools are always in
operating condition.
Fig. 6
Square
Drive Anvil
Fig. 7
Square
Drive Anvil
Adapter
13