Important Information; Identification Of Parts; Date Of Manufacture; Assembling Your Stroller - Evenflo LUX 24 Manual Del Usuario

IMPORTANT INFORMATION

Child Requirements
Maximum weight: 50 lbs (22.6 kg)
Maximum height: 38 inches (96 cm)
IMPORTANT: Read instructions carefully before use. Save these instructions for future reference. It is very important to assemble
the stroller according to these instructions. DO NOT USE YOUR STROLLER UNTIL YOU HAVE READ AND UNDERSTOOD
THESE INSTRUCTIONS.
If you are missing parts, do not use stroller and call Evenflo ParentLink at 1-800-233-5921 (U.S.A.), 1-937-773-3971
(Canada), or 01-800-706-12-00 (Mexico) to order replacement parts.
Registration Information
Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your personal
information. To register your product, please complete and mail the card that came with it or visit our online registration at
www.evenflo.com/registerproduct.
For future reference, record the Model Number and Date of Manufacture below. You can find this
information on one of the rear stroller legs.
Model Number:

IDENTIFICATION OF PARTS

(2) Front Wheel Assembly
(4) Washer
(2) Hub Cap
Visor
2

Date of Manufacture:

(2) Rear Wheel Child Tray Assembly:
Bumper Bar and
Child Tray Insert
(2) Clevis Pin
(on some models)
Rear Axle
1
2
Cup Holder
H G F E
WARNING
Care must be taken when folding or unfolding
stroller to prevent finger injury in hinge areas.
To protect flooring, place a protective covering
(cardboard, towel, small rug or blanket) beneath
the stroller during assembly.
A
Unlatch side frame lock
Continue holding the lock open
while unfolding the stroller.
B
A
Grab the parent's handle
and pull upward until the stroller opens fully with an
audible click. Make sure the stroller locks in the open
position by pushing down on the parent's handle.
Turn the stroller upside down, as shown, so the rear of the
stroller is facing upwards.
C
D
Slide rear axle
Slide a washer
F
the axle. Slide a washer
of clevis pin
G
wheel. Repeat steps to attach other rear wheel.
Pull on the wheels to make sure they are locked securely.

ASSEMBLING YOUR STROLLER

.
A
near the top of the canopy
B
into tube as shown.
C D
onto the axle. Slide a rear wheel onto
F E
onto the axle. Insert straight side
F
through hole in axle. Snap hub cap onto
H
3