What To Do If - Zanussi ZOB10401 Manual De Instrucciones

2
1
7
Carefully lift (step
1) and remove (step
2) the glass panel.
Clean the glass panel with water and soap. Dry
the glass panel carefully.
Installing the door and the glass panel
When the cleaning is completed, install the
glass panel and the oven door. Do the above
steps in the opposite sequence.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The appliance does not operate.
The appliance does not operate.
The oven lamp does not operate.
Steam and condensation collect
on the food and in the oven.
If you cannot find a solution to the problem
yourself, contact your dealer or the service cen-
tre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
www.zanussi.com
The screen-printing zone must face the inner
side of the door. Make sure that after the instal-
lation the surface of the glass panel frame on
the screen-printing zones is not rough when you
touch it.
Make sure that you install the internal glass pan-
el in the seats correctly. Refer to the illustration.
Possible cause
The appliance is not activated.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
You left the dish in the oven for too
long.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity.
Remedy
Activate the appliance. Refer to
the chapter "Daily Use".
Do a check of the fuse. If the fuse
is released more than one time,
contact a qualified electrician.
Replace the oven lamp.
Do not keep the dishes in the oven
for longer than 15 - 20 minutes af-
ter the cooking ends.
.........................................
.........................................
.........................................
11