Safety Warnings - Cristher PAR56 OnLED Manual De Instrucciones

5. CHANGE OF LAMP:
To remove the projector to the edge of the swimming pool (Fig. 5) loosen the two screws of the decorative ring until the
fixation system fastening dog yields sufficiently so that the projector unit can be separated from the housing.
Step 1:
Change of lamp STD projector
To remove the lamp, unscrew the 6 nuts which secure the decorative ring to the base of the projector (Fig. 5).
Unscrew the two cap nuts (A), remove the two O-rings (B) and completely unscrew the two screws (C), see Fig. 6.
Remove the lamp from the inside of the base of the projector and disconnect the two terminals, loosening the two screws
which secure them to the lamp. (Fig. 9).
Change of lamp Global projector
Unscrew the 6 nuts that fix the trim ring at the bottom of the projector (Fig. 5).
Unscrew the two cap nuts (Z), and completely unscrew the two screws (X), see Fig. 8.
Extract the lamp from the inside of the bottom projector and disconnect the 2 terminals, loosening the two screws that
fix them to the lamp (Fig. 9).
Step 2:
Change the lamp and assemble the Projector, in the opposite order described, taking special care to:
• Connect the cable terminals to the lamp, using the 2 screws supplied with the lamp (Fig. 9).
• Fully centre the O-ring in its seat.
• Firmly tighten the nuts (Maximum torque 2 Nm).
Attention:
• In the OnLED v2 models it is essential that the direction of the lamp is adequate, situating "TOP" on the top part of
the projector.
• Before any handling ensure that there is NO voltage supplied to the projector .
• The new lamp should have the same characteristics as that supplied with the projector.
• In order to ensure full watertightness, clean the seat of the O-ring (no. 7) for the lamp or replace the O-ring if you observe
any notches or permanent damage.

6. SAFETY WARNINGS:

• People in charge of assembly should be suitably qualified for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING
POOLS.
• All maintenance operations should be performed with the projector disconnected from the Mains.
• Do not handle with wet feet.
7. ASSEMBLY AND FUNCTIONING WARNINGS:
THE HOLES AT THE BACK OF THE LAMP v2 (FIG. 10) SHOULD BE LEFT FREE WHEN ASSEMBLING THE PROJEC-
TOR, SO THAT WATER CAN FLOW INSIDE FOR OPTIMUM PERFORMANCE OF THE LAMP.
• It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically
conceived to work with ABS, all those products of universal use remain excluded.
• The projector is designed TO OPERATE ONLY WITH A SAFETY TRANSFORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric compo-
nents which have been inserted or handled at locations other than its own premises.
• It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
• The STD projector is not designed to work submerged in seawater.
• The Global projector is seawater resistant.
• This projector is resistant to pool treatments described below, always that the concentration values do not exceed the
following levels:
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
TYPE OF TREATMENT
ATTENTION
CONCENTRATION IN WATER
3
2 g/l
5 g/l
6 g/l