Facom BAT.TEST Manual Del Usuario página 6

BEFORE TEST
1. Before you test a battery in a vehicle, turn off the ignition, all
accessories and loads. Close all the vehicle doors and the trunk lid.
2. Make sure you have put 4 AA 1.5V batteries into the battery
chamber. Oxyride batteries are NOT recommended because of the
initial 1.7 Volt output. If the internal 1.5V batteries run out of power,
the display will show "POWER LOW". Replace those AA 1.5V
batteries before starting a new test.
Note that nothing will be seen on the display until the tester is
connected to a vehicle battery.
3. Make sure the battery terminals are clean. Wire brush them if
necessary. Connect the red clamp to the positive battery terminal
post; connect the black clamp to the negative battery terminal post.
For the most accurate results, clamp on the lead part of the terminal
only. Attaching to the clamp or fixture rather than directly on the
terminal will lead to unstable wrong test results.
4. Paper load:
a. Open the clear cover.
b. Place a new paper roll
in the compartment.
c. Paper will be fed automatically
when the sensor of printer is sensed.
b
- 4 -
a