Lightway SP-2016PIRB Manual Del Usuario página 5

The security light is intended for use with the enclosed gasket and with a
14.
junction box marked for use in damp conditions.
The mounting bracket mounts to recessed or surface standard junction boxes.
15.
Junction box must be at least 1-1/2 inches in depth for proper installation.
To protect against electrical shock, do not immerse unit or wires in water or
16.
any other liquid. This is an electrical appliance.
DO NOT use the security light for other than for its intended use.
17.
Always aim the motion sensor toward the targeted detection zone.
18.
Detection range is 180° with 50 feet horizontal.
19.
Close supervision is necessary when any appliance is being used by or near
20.
children. This security light is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge.
DO NOT install or operate the security light with damaged wires or parts or if
21.
the light malfunctions or is dropped or damaged in any manner. If the
security light malfunctions, has broken parts, or any parts are missing, contact
customer service.
The use of accessory attachments not recommended by the manufacturer
22.
may result in fire, electrical shock, or risk of injury.
Avoid contact with moving parts.
23.
If you want to use manual mode, the light must be wired through a switch.
24.
Warning: After installation of the security light, no further rotation positioning
25.
should be done.
SAVE THESE INSTRUCTIONS!
General information
5