Kübler Sendix 58 FS2 Serie Manual De Instrucciones página 50

Flange with flexible torque stop
SW 3
50 - EN
Assembly requirements
During the assembly, make sure that
• The torque stop is mounted in not pre-tensioned condition
• The nuts are secured against loosening.
• The torque stop shows no deformation.
• The used slot of the fastening arm has not been damaged
• Comply with the maximum permissible shaft offset.
27021597825821963
Threaded rod
In case of high efforts (e.g. high rotary speeds and reversing
operation), the threaded rod can suffer wear and must be in-
spected periodically. In this case, replacing the threaded rod /
the torque stop may become necessary.
• Make sure to oversize the fastening in the motor flange.
• The threaded rod must be secured against loosening.
on a M4 threaded rod with two M4 nuts.
when shortening.
BA Sendix® 58xxFS2 / 58xxFS3 - R60049.0009 - 05
NOTICE
NOTICE