Application Side - Kübler Sendix 58 FS2 Serie Manual De Instrucciones

Flange Type B with Stator Coupling
For (4x) M3 screw
Status LED
SET button
Central screw tapered shaft M4
4.1.3.3.1 Assembly Instructions for Tapered Shaft
Encoders
a) Block the drive shaft for the assembly.
b) Tighten the central screw of the tapered shaft.
c) Comply with the maximum permissible shaft offset.
d) Screw the stator coupling or the torque stop without pre-
load on the drive flange.
52 - EN
e) Secure the screws against loosening, see chapter

4.1.3.4 Application Side

Requirements for the application side for the mounting of the
encoders.
For hollow shaft encoders
45035996335298187
Material: Steel, stainless
Encoder damage
Device failure, device lifetime reduction.
• Comply with the minimum insertion depth of the drive in the
Screw Retention [} 53].
0,1
Ra 1,6
ATTENTION
hollow shaft encoder.
BA Sendix® 58xxFS2 / 58xxFS3 - R60049.0009 - 05
53088907