Emerson IDEAL CF330BQ00 Manual Del Usuario página 6

3. Ceiling Fan Assembly
3.3
NOTE: Take care not to scratch the fan housing
when installing the blade assemblies.
Attach the Blade Flange Assembly onto the Fan Motor/
Hub by tightening the 1/4-20 x 1/2" Oval Head Screws
securely (Figure 3).
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
3.4
Remove one of the three #6-32 x 3/8" Tress Head
Screw with Lockwasher from the Motor Assembly Hub,
retain the screw for future use.
Loosen the remaining two #6-32 x 3/8" Tress Head
Screws with Lockwashers.
Place the 2-pin motor assembly connector through the
large center hole of the Light Kit Housing Assembly
(Figure 4).
Position the Light Kit Housing Assembly key hole slots
onto the two loosened screw heads. Rotate the Light Kit
Housing Assembly clockwise to engage the two screws.
Verify that the serrated washers are not trapped
between the Light Kit Housing Assembly and the Motor
Assembly Hub.
Reinstall the previously removed #6-32 x 3/8" Tress
Head Screw with Lockwasher (Figure 4).
Retighten all three #6-32 x 3/8" Tress Head Screws with
Lockwashers to securely attach the Light Kit Housing
Assembly to the Motor Assembly Hub (Figure 4).
A spare #6-32 x 3/8" Tress Head Screw with Lockwasher
is in the hardware bag, if needed.
Carefully turn the partially assembled ceiling fan right
side up and position the fan on the styrofoam in
preparation for additional assembly.
(Continued)
Figure 3
LIGHT KIT HOUSING
ASSEMBLY
Figure 4
6
1/4-20 x 1/2" OVAL HEAD SCREWS
(2 per assembly)
BLADE FLANGE ASSEMBLY
MOTOR HUB
#6-32 x 3/8" TRESS
HEAD SCREW WITH
LOCKWASHER
ROTATE CLOCKWISE
ETL Model No.: CF330