Blue Clean AR 383 S Manual Del Usario página 12

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Spray
1
1
12
15ANR012 AR383S_1800PSI ENG-FR-SP.indd 12
Pressure
2
Operation Tips
• If you hear the motor run intermittently when the trigger
is not being squeezed, that is normal.
The pump is priming itself so it is ready to operate when
the trigger is squeezed. Turn off the power washer if not
being used after five minutes.
• The o-rings on the bayonet end of the nozzle lance
should be cleaned regularly and lubricated with non-
water soluble grease such as petroleum jelly.
• Keep the nozzle cleaning wire for use in unclogging
the nozzle. If you lose the cleaning wire, a straightened
paper clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs because
the impact force of the water pressure exceeds the
durability of the surface. Bare wood can be penetrated;
paint can be peeled off, etc. You can vary the force of
your power washer by controlling:
1. The angle of the surface being cleaned
2. The distance of the nozzle from the surface being
cleaned
• NEVER use a narrow high pressure stream of water on
soft surfaces susceptible to damage.
• Use the high/low nozzle lance when cleaning windows.
Be sure to adjust the nozzle to low spray and place
the nozzle approximately four to five feet away from
the window with the nozzle at forty five degree angle.
Squeeze the trigger and vary the spray pattern and
angle until optimum cleaning efficiency is achieved.
16/12/17 下午2:28