Blue Clean AR 383 S Manual Del Usario página 7

ASSEMBLY INSTRUCTIONS
3
4
J
B
Connect the other end of Soft PVC high pressure hose
(B) to spray gun (J) by inserting the brass metal tip of
high pressure hose into the fitting just ahead of trigger
guard. It will lock into spray gun with a "click". Confirm
hose is locked into spray gun by slightly pulling on them.
The hose is now securely attached to spray gun.
Note: DO NOT press button on underside of gun when
connecting hose to gun.
15ANR012 AR383S_1800PSI ENG-FR-SP.indd 7
A
B
Soft PVC High Pressure Hose Assembly
Screw Soft PVC high pressure hose (B) clockwise
onto bottom left, when facing the unit, front of power
washer unit (A). Pull back collar and insert o-ring post
into water outlet far enough so collar can thread onto
outlet threads until hand tight. If it takes fewer than six
turns you have not properly tightened the Soft PVC high
pressure hose fitting. It is easier to position the power
washer in front of you to ensure that the threads are
started correctly. Failure to properly tighten Soft PVC
high pressure hose will result in the hose slipping or
popping off immediately upon turning unit on. Do not
worry about damage if this occurs–just reinstall and
take extra care when screwing on the high Soft PVC
pressure hose fitting.
Note: DO NOT use pliers or locking pliers to tighten.
5
J
B
2
To release hose (B) from spray gun (J), press button on
underside of gun toward trigger guard. The hose will
slide out from connection.
7
16/12/17 下午2:28