Vetus WWCP Manual De Manejo Y Instrucciones De Instalación página 17

Setting the 'Minimum tank level' .
• Hold the float in the EMPTY position.
• Press the key once.
• Press the key.
Explanation:
- Float sensor:
- Ultrasonic sensor: hold the sensor at a distance from a reflective
Setting the 'Finishing time'
• Press the key repeatedly to move through the possible settings.
The set value will be shown by one of the 'Tank level' LEDs.
• Press the key.
Explanation:
After the tank has been emptied, the pump can still run for a few min-
utes. This is desirable if the level sensor does not measure over the
whole range of the tank.
The tank level LEDs show the finishing times:
100% 100%
75% 75%
50% 50%
25% 25%
30 s 5 min
vetus® Waste water control panel WWCP
hold the float in the lowest position.
surface equal to the height of the tank.
Note: The sensor must be held steady in this
position for approx. 10 seconds.
100%
75%
50%
25%
10 min
Continued from previous page.
A
Make sure that an
ultrasonic sensor has been
calibrated; see 'Installation
instructions SENSORA'
090429.01, 'Calibration' .
100% 100%
75% 75%
50% 50%
25% 25%
20 min 30 min
B
Continue on the next page.
ENGLISH
OR
• Press the
key to
bypass setting
the 'Minimum
tank level' .
OR
• Press the
key to by-
pass setting the
'Finishing time' .
17
090427.02