Installation Instructions; Installing Quick-Connect Filter; Un-Installing Quick-Connect Filter - PUR PQC1FS Manual Del Propietário

Installation Instructions:

The filter(s) of PQC1FS and PQC2FS Systems have been pre-assembled and tested at the factory. To check or replace the filter(s),
the following steps need to be implemented:
Installing the Quick-Connect Filter (See Figure 1):
1. Unlock the Locking Tab by sliding it from the right to the left
side of the slot to 'Unlock' Position.
2. Lift the filter top section into the Head. Turn the filter about
1/4 turn in the direction as shown in Figure 1 until it stops.
3. Slide the Locking Tab from left to right of the slot to 'Lock'
position.
Un-installing the Quick-Connect Filter (See Figure 2):
1. Unlock the Locking Tab by sliding it from the right to the left of
the slot to 'Unlock' Position.
2. Turn the filter in the direction as shown in Figure 2 about 1/4
turn until it comes out of the Head.
NOTE: The filter head can be swung forward to assist in
the filter installation/removal.
CAUTION: Some water will drip during filter removal so
use a tray to catch any spillage.
CAUTION: Do not attempt to turn the filter housing while
in the 'Lock' position. It may damage the system and
cause leaks.
3
Figure 1.
Figure 2.
45˚
1/4
45˚
1/4