Connecting The Tubing From Water Line To System; Connecting The Tubing From System To Faucet; Connecting The Tubes Using Quick-Connect Fittings - PUR PQC1FS Manual Del Propietário

Installation Instructions (continued):
Connecting Tubing from Water Line to System (See Figure 7):
1. Determine the length of 1/4" Tubing (D) from Inlet Valve (G) to the Inlet of Head Assembly (A) by holding Tubing in place
ensuring it is of appropriate length. Cut the Tubing square with a utility knife.
CAUTION: Do not kink Tubing as this will impede water flow.
2. Wet one end of the Tubing with water and push it onto the guide tube of the valve until it stops.
3. Hand-screw the Inlet Compression Nut (H) on the valve and tighten with adjustable wrench.
4. Push other end of the Tubing into the Inlet of Head Assembly (A) by referring to the instructions of "Tubing Connection with
Quick-Connect Fittings."
Connecting Tubing from System to Faucet (See Figure 7):
1. Determine the length of 1/4" Tubing (D) from the outlet of Head Assembly (A) to the stem of the Faucet by holding Tubing in
place ensuring it is of appropriate length. Cut the Tubing square with a utility knife.
CAUTION: Do not kink Tubing as this will impede water flow.
2. Gently slide Faucet Compression Nut (Q) down over the Tubing. Follow with Ferrule (P). Push Insert (O) into the end of the
Tubing.
3. Firmly push the Tubing into the stem of Faucet until it stops. Hand-screw the Nut onto the threads of the stem. Tighten with
wrench.
CAUTION: Do not overtighten the Compression Nut.
4. Push other end of the Tubing into the water outlet of Head Assembly (A) by referring to the instructions of "Tubing Connection
with Quick-Connect Fittings."
Connecting the Tubes Using Quick-Connect Fittings (See Figure 8, 9 and 10):
1. Remove the blue Horseshoe Clip from Collet. (Figure 8)
2. Pull out and discard the protect plug by pushing the Collet inward and holding with fingers. (Figure 9)
3. Insert Tubing into the Collet. Full engagement is 11/16" length of the Tubing into the fitting. (Figure 10)
NOTE: Ensure Tubing is pushed all the way to backstop.
4. Put blue Horseshoe Clip back on Collet.
Figure 8
Collet
Horseshoe Clip
Figure 9
O-Ring
Figure 10
Backstop
Full engagement length
6