Operation; Maintenance; Routine Cleaning - Omcan PE-CN-0015 Manual De Instrucciones

Operation

LOADING AND WORKING THE PRODUCT
Note: The goods to be worked are loaded gradually on the cap from the upper cover when the motor is
off.
Adhere to the following procedure:
1. Load the product from the upper cover, making sure that the discharge door is closed well.
2. Check that the machine is not too full and that the level of the product does not go over the abrasive band
inside the machine.
3. Close the upper cover.
4. Open the water flow using the faucet on the hopper.
Running:
1. Set the desired work time with the timer (maximum time 5 minutes).
2. Then start the machine by pressing the START push button.
3. If the cover and/or discharge door are accidentally opened or moved while the machine is running, the
machine will stop; when closed press the START button.
4. Open the water flow using the faucet on the hopper.
5. If the machine is outfitted with a stand with sieve, repeatedly unload the slag tray, to avoid the water
dripping.
Unloading the worked product:
1. Close the water faucet and put a big container near the discharge outlet.
2. To unload the material open the discharge door keeping it open with your right hand; press the OUT and
START push button at the same time with OUT your left hand; the machine will start unloading the product
by centrifugal force.
3. Once the unloading is complete the machine will stop by releasing the push buttons and the discharge
door.
Note: Avoid making an empty machine turn.

Maintenance

ROUTINE CLEANING

ATTENTION: Never put hands inside the moving machine.
Cleaning and maintenance operations are carried out only when the machine is off and the feeding cable is
unplugged.
Before cleaning the machine the feeding plug must be disconnected from the network to completely isolate the
machine.
• The machine must be cleaned at the end of every work day and all the parts of the machine (completely
8