Publicidad
Idiomas disponibles
Idiomas disponibles
9. At the fender edge next to the battery, remove the
existing ground wire hex nut. Position the ground
ring terminal from the main harness (B) and reattach
the nut to secure.
10. Locate the rubber grommet at the back of the engine
compartment. Cut away the end of the access nipple
and feed the end of harness (B) through to the inside
driver footwell. Apply RTV sealant to the hood switch
wiring convolute and pull the wiring into the nipple
to seal the wiring at the nipple.
11. Remove two fasteners at the bottom of the trim panel
under the steering wheel and carefully pry off the hood
release latch. Disconnect the data link connector and
pry off the trim panel. Pull the Switch Harness (B)
through to the inside footwell.
7/28/15
5
Publicidad
