Mopar K6862495AB Manual Del Usario página 5

7. Route the switch harness (B) along the existing
vehicle harnesses on the driver side and back
towards the rear of the engine compartment.
Tuck the harness behind the fuse box as shown.
8. At the fender edge next to the battery, remove the
existing ground wire hex nut. Position the ground
ring terminal from the main harness (B) and reattach
the nut to secure.
9. Locate the rubber grommet at the back of the engine
compartment. Cut away the end of the access nipple.
9/16/16
5