Lutron QS Keyswitch Guia De Instalacion página 6

3b. For keyswitches with fine tune function: On the
GRAFIK Eye QS control unit, press and hold both
®
the raise and lower buttons for the zone you want the
keyswitch to fine tune. Repeat for each zone you wish
to "listen" to the selected keyswitch, or for zones on
additional control units. When listening, zone LEDs
flash. When unassigned (not "listening"), the 3 middle
zone LEDs light.
Note: To stop a zone from listening to a keyswitch, put
the keyswitch in setup mode, then press and hold
both the raise and lower buttons on the zone you
want to stop listening. The 3 middle zone LEDs
will light.
Press and hold the raise and lower
buttons for the zone you want to
listen or stop listening.
1 2 3 4 5 6
Proceed to Step 4.
3c. For keyswitches with zone function: On the
GRAFIK Eye QS control unit, for the zone you want
to "listen" to the keyswitch, use the raise and lower
buttons to set the desired levels. The LEDs will
indicate the level. Then, press and hold both those
raise and lower buttons to make that zone "listen"
to the keyswitch. When listening, zone LEDs flash.
When not listening (unassigned), the 3 middle
zone LEDs light.
Repeat for each zone you wish to assign to the
selected keyswitch, or for zones on additional
control units.
Note: To stop a zone from listening to a keyswitch,
put the keyswitch in setup mode, and press
and hold both the raise and lower buttons on
the zone you want to stop listening. The 3
middle zone LEDs will light.
Proceed to Step 4.
Installation Instructions
OK
3d. For keyswitches with shade control function:
Each tap of the program button wiggles the next
shade on the link; each double-tap wiggles the
previous shade on the link. Shades are assigned
using the right keyswitch position and unassigned
using the left position. To assign or unassign a
shade, move the key into the respective position
and hold it for 5 seconds.
Note: Unassigned shades will move to their open
position, and assigned shades will move to their
closed position.
Proceed to Step 4.
4. Exit Setup Mode. Press and hold the Program
button on the keyswitch for 5 seconds. The LEDs
will return to normal.
Programming to Sivoia
For shade control with no GRAFIK Eye QS control
unit on the link, enter setup mode on the key-
switch. Turn the key to the right position, triple-tap
the program button, and within 20 seconds turn
key to the left position and triple-tap the program
button again.
Proceed to Steps 3d and 4.
Programming to Quantum
For keyswitches that are part of a Quantum sys-
tem, all system communication and programming
is done via the Quantum software instead of fol-
lowing the steps above.
6
QS
®
System
®
Occupant Copy