Optelec
5. Power and Battery Use
Checking the battery status
Press the Back and Forward buttons together to check the battery status. The ClearReader
announce the status in percentage, where 100% means a fully charged battery. If the battery is
low, please charge the battery with the dedicated power supply.
Charging the ClearReader
To charge the ClearReader
connector located at the rear side of the unit. Plug the other side of the adaptor into a power
outlet.
Charging the ClearReader
operate for approximately 5 hours. Please note that, for safety reasons, only the adaptor
supplied by Optelec should be used to charge the ClearReader
Extending the battery life
To ensure the battery pack maintains maximum capacity, disconnect the ClearReader
power source at least once a month and operate it on battery power until the battery pack is
empty.
English
+
battery
+
, connect the mains adaptor supplied in the box to the power
+
takes approximately 3 hours. A fully charged ClearReader
ClearReader
+
.
+
+
will
+
can
+
from the
Page 17