Technical Data - Beta 1498TB Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR EYE PROTECTION
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE
OPERATING BATTERY TESTER
Additional personal protective equipment to wear according to the values found in
the environmental hygiene/risk analysis survey if the values exceed the limits under
current regulations.

TECHNICAL DATA

FOR USE WITH BATTERIES
OPERATING VOLTAGE
CAR OPERATING RANGE (CCA)
MOTORCYCLE OPERATING RANGE (CCA)
BATTERY TESTING TIME
INTERNAL BATTERY CAPACITY
OPERATING TEMPERATURE
DIMENSIONS
CLAMP CABLE LENGTH
WEIGHT
SECURING PRINTER (OPTIONAL)
The unit can accommodate the printer (optional accessory), so that the results can be printed immediately
after each test. To secure the mobile printer in position, first remove the cover from the tester back. Then
fit in the printer, making it slide as far as its fixing point. Open the ticket compartment, and secure the
printer by means of the supplied screw. Fit in the roll with the end part turned upwards. Make sure that
the paper sticks out by at least 2 cm before closing the compartment.
SETTING UP TESTER
To set up the tester, move onto the item "Setup Menu", where you can select the following: "Language",
"LCD Brightness", "Set date & time", "Company name" and "Erase Memory" (the last mentioned setting
allows all the stored tests to be erased). Use the ▼▲ keys to select the item to set, and press "Enter"
to get into the individual sections. Use the ▼▲ ◄ ► keys to input the data, and press "Enter" to
confirm selection.
NEW TEST – CONTINUE TEST – INTERNAL MEMORY
Whenever a new test needs to be started, press ▼▲ to move onto the item "New Test", and press
"Enter". A new set of tests can then be started on the motor vehicle (battery, grounding, starter or
alternator). Once a test (e.g. a battery test) has been completed, you can perform the other tests,
or return to the initial menu; if you return to the initial menu, but want to continue the previously started
test, use the ▼▲ keys to select the item "Continue Test...", and press "Enter". The tester will
automatically bring you back to the screen that allows the type of test to be selected, and you will be
able to continue with a different test on the motor vehicle, without losing the previously saved data.
The tester is fitted with the internal memory, "Stored Results", which can record test data, so that they
can be later input into the computer or checked without the test being performed again.
14
12V
9V ~ 36V DC (max)
100A ÷ 2000A
40A ÷ 600A
<8 seconds
Stores up to 70 test results
0 °C ÷ + 50 °C
180x135x45 mm
1.6 m
0.74 kg
EN I