Mounting The Roller Track Set Of The Machine - Bosch TCE 4460 Manual Original

i
In order to ensure safe and ergonomic use of the
TCE 4460, it is advisable to position the device at a
safe distance of at least 500 mm from the nearest
wall, and to take into consideration the maximum
space requirements for the moving elements when
moving the device into the working position.
i
Rubber vibration dampers (A) are fitted at the desi-
gnated points to ensure low-vibration mounting on
the floor.
Fig. 32: Vibration dampers
6. Fill the lubricant tank with commercially available
tire mounting paste.
i
Do not use a solvent-based lubricant as this could
damage the tires, and do not use any flammable
liquids to lubricate or position the tire beads.
7. Re-attach the guards.
Fig. 33: Re-attaching the guards
Robert Bosch GmbH
Commissioning | TCE 4460 | 51
4.2.8

Mounting the roller track set of the machine

1. Using a socket wrench, secure the mounting rail for
the roller track (A) to the machine housing with the
self-tapping screws (B) provided. There are two holes
for this beneath the lower plastic support.
Fig. 34: Anchoring the mounting rail on the housing
i
The mounting rail for the roller track has 6 holes. The
mounting rail can therefore be secured in 3 different
positions.
2. Using a hex key, secure the lower section of the roller
track (C) to the mounting rail (A) with the screws (D)
provided.
Fig. 35: Anchoring the roller track on the mounting rail
en
|
1 695 105 428 2013-11-04