KTM Power Parts 76014937044 Manual Del Usuario página 6

7
6
4
8
12
11
3
9
10
13
4
4
14
- Detach the plate (8) from the original turn signal relay (7) and attach it to
the new turn signal relay (4).
- Connect the connector (13) of the adapter cable (3) (included) to the turn
signal relay (4) (included).
- Connect the connector of the original turn signal relay (9) with the con-
nector (10) of the adapter cable.
- Connect the flat pin connector (11) with the ground wire (brown) of ACC1
(12).
- Mount the turn signal relay (4) (included) with the washer (14).
- Connect the headlights and LED turn signals.
- Mount the headlight mask (see the Owner's Manual).
NOTE:
To remove the turn signals, the license plate holder may have to be first,
depending on the model.
- Remove the original turn signals at the rear and disconnect them.
- Mount the LED turn signals at the rear and connect them.
Final steps
After installation, the entire lighting system must be checked for proper func-
tioning.