Sony TRINITRON KV-27FS13 Manual De Servicio página 136

Cable Box and Cable
Use this connection if you subscribe to a cable system that scrambles
some channels (pay channels), but not all of them. This set up allows you
to use the remote control to:
change channels through your cable box when you are receiving a
a)
scrambled signal, and
change channels through your TV.
b)
This connection also allows you to use the PIP feature when you are
viewing unscrambled channels coming directly into your TV from your
cable. Scrambled signals coming through the cable box cannot be viewed
in PIP. For more information on the PIP feature, see page 18.
2
1
CATV cable (unscrambled Channels)
1
Connect the coaxial cable from your cable service to the VHF/UHF
jack on your TV.
2
Using a coaxial cable (not supplied), connect the IN jack on your
cable box to the TO CONVERTER jack on your TV.
3
Using a coaxial cable (not supplied), connect the OUT jack on your
cable box to the AUX jack on your TV.


Pressing the
box and direct cable inputs.


Your Sony remote control can be programmed to operate your cable box,
(see page 38).


To use the cable box to change your channels, set your TV to channel 3 or 4.
Setting the Channel Fix feature will assure you don't accidentally switch the
channels using your TV, (see page 27).
Cable Box
3
Coaxial Cable
75-ohm coaxial cable
button on the remote control switches between the cable
Connecting Your TV
Rear of TV
5