Automated Learning Process./ Activating Code; Wall Control Operation - Craftmade TAN56BNK5 Guia De Instalacion

11. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 for the transmitter. Use
the same number sequence used when wiring the
wall control in Section 6 (page 6).
Note: Since this fan comes with a halogen bulb, the
dimmer switch (labeled D and X) has been pre-set
to the "ON" position (D). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (X).
Install one 12-volt battery (included) in transmitter.
Re-attach battery cover on transmitter.
Restore electrical power and then set slider switch
on wall control to the ON position. Within 30
seconds of turning on the wall control, press the
fan "OFF" button ( ), located on the front of the
transmitter, for 5 seconds or until light blinks twice.
Test the light and fan functions to confirm the
learning process is complete--see Section 14.

12. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L button - turns light ON/OFF when pressed once;
dims light when pressed and held down
dimmer
switch
page 9
code
transmitter
switches
(back)
12V battery
battery
cover
transmitter
(front)