Wiring; Canopy Assembly - Craftmade Ellington E-BFT52ABZ5C Guia De Instalacion

7. Wiring.

CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions
below, please use a qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket, electrical wiring can be made
as follows:
Connect BLACK and BLUE wire from fan to
BLACK wire from ceiling with wire connector
provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch, connect BLUE wire from
fan to the BLACK (or RED) supply from the
independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote
control sold separately).

8. Canopy Assembly.

Temporarily raise canopy to hanging bracket
to determine which screws in hanging bracket
align with slotted holes in canopy, and then
lower canopy and partially loosen these 2
screws. Remove the other 2 screws and set
aside.
Now, lift canopy to hanging bracket, aligning
slotted holes in canopy with loosened screws
in hanging bracket. Twist canopy to lock.
Re-insert the other 2 screws and secure all
screws with Phillips screwdriver.
white supply wire
black supply wire
from ceiling
black
white
white
black
blue
from fan
page 6
ground
(green or bare)
ground
(green
or bare)
*
hanging bracket
canopy