Performing A Control Solution Test - Fora 6 Connect Manual Del Propietário

Performing a Control Solution Test

2. Apply control solution
Shake the control solution vial thoroughly before use. Squeeze out a
drop and wipe it off, and then squeeze out another drop and place it on
the tip of the vial cap. Hold the meter in an angled position so that the
absorbent hole of the test strip touches the drop. Once the confirmation
window fills completely, the meter will begin counting down. To avoid
contaminating the control solution, do not directly apply control solution
onto the strip.
3. Read and compare the results
After the meter counts to 0, the result of the control solution test will
appear. Compare the result with the range printed on the test strip vial.
The result should fall within this range. If not, please read the
instructions again and repeat the control solution test.
1. Insert the test strip to turn on the
meter
Insert a test strip into the meter. Wait
for the meter to display a flashing " ".
15